Four Conductor Power Cable (PT1)
It is strongly discouraged by FLI to modify the power cables, or use third party power supplies. Any damage done to the camera as result of third party power supplies or tampering with the power supply unit will not be covered under warranty. The following information is for informational use only.

FLI cameras' power connector is a four conductor cable which provides 12V power to the system. The shield of the 4-Pin Jack Socket (KPJX-4 at www.mouser.com) is connected to ground. The PT1 cable is shown below.

The FLI power supply outputs 12V at 10A from an input of 100-240V AC at 2.0-1.0A at 50-60Hz.

WARNING: If the polarity of the power connection is reversed it can cause damage to the camera. This damage will not be covered by the FLI product warranty. Verify the polarity of the voltage using a meter before attaching a power cable to the camera. Also verify the chosen system has the same current capability.
Finger Lakes Instrumentation
200 Tech Park Drive
Rochester NY 14623 USA
Phone: 585-624-3760
Email: sales@flicamera.com
Web: https://flicamera.com
©2024 Finger Lakes Instrumentation